1Cr25Ni20Si2 Tube Shield
1Cr20Ni14Si2 boiler erosion shield boiler parts for economizer and water cooling wall pipeline.
Stainless 1Cr25Ni20Si2 tube shields are made of 1Cr25Ni20Si2 stainless steel and can be customized to fit perfectly straight sections, curved sections and even finned and Specialty tubes.
1Cr25Ni20Si2 material is GB GB 4238 (1992) Heat-resisting steel sheets and plates GB GB/T 1221 (1992) Heat-resisting steel bars Heat-resisting steel sheets and plates.
Chemical composition of 1Cr20Ni14Si2, 1Cr20Ni14Si2 mechanical properties, 1Cr20Ni14Si2 datasheet, 1Cr20Ni14Si2 equivalent grade, Heat treatment and temperature process of 1Cr20Ni14Si2.
Shapes and specifications of tube shields
The cross-sectional shape of boiler tube shields is mostly semi-circular (180 degrees), and there are also 120-160 degrees. It is mainly used on finned tubes (water-cooled walls); boiler tubes erosion shields are divided into direct wear-resistant shields, in-curve, anti-wear shields, outer-curve, anti-wear shields, side-curve anti-wear shields, s-curve anti-wear shields, etc.
Tube shields-outside bend and side bend types
The length of the straight anti-wear shields ranges from 20mm to 3000mm, and the general length of 1000-2000mm is commonly used. The anti-wear shields with bends generally requires a processing drawing and the following parameters should be on the drawing: outer diameter of the pipe used, bending of the pipe Radius R (to the center of the pipe), the degree of bending angle, and the length of the straight sections on both sides of the arc segment of the wear-resistant shields.
“snap-on” type shield
The most basic parameter of boiler tubes shields is the outer diameter of the tube used (that is, the inner diameter of boiler tubes erosion shields). The main specifications of the tube are: 32, 38, 42, 44.5, 48, 51, 57, 60, 63.5 , 76, 89mm, etc . the inner diameter of the boiler tubes erosion shields is usually 1-3mm larger than the outer diameter of the tube used, depending on the actual requirements.
Tube shields production process
To ensure the accuracy of the material. Positive Material Identification (PMI) of stainless steel sheets for tube shields is critical to verifying the grade and composition of stainless steel before it goes into production.
Tube shields from us are manufactured to exacting standards. Advanced equipment and material handling capabilities permit us to offer the fastest turnaround times anywhere.
The current production process for tube shields is to use high-pressure presses and professional moulds for pressing.
The production time is short, the welding performance is good, the welding seam does not fall off, the surface is smooth and the appearance is beautiful. The arc-shaped wear-resistant tile is pressed on a press or bent on a pipe bender with a special mould.
